44 Chapter 2: Printing Tasks
EN
Printing Transparencies
Use only transparencies recommended for use in laser printers. For
transparency specifications, see page A-8.
• Load transparencies face up in Tray 1 with the top toward the
printer.
• A stack of 50 to 100 transparencies can be printed from other
trays. Because transparencies are heavier than paper, do not
load the other trays to capacity. For orientation in other trays, see
Figure 11 on page 36.
• To prevent transparencies from becoming too hot or sticking
together, use the top output bin by closing the rear output bin
(page 24). Remove each transparency from the output bin before
printing another.
• Place transparencies on a flat surface to cool after removing them
from the printer.
Figure 14 Printing Transparencies
To Next Page
Loading...