EN
Chapter 4: Problem Solving 75
/'/14;5'66+0)5
%*#0)'&
The printer changed its memory settings because it did not have
enough memory to use the previous settings for I/O Buffering and
Resource Saving. This usually occurs after removing memory from
the printer, adding a duplexer, or adding a printer language.
You might want to change memory settings for I/O Buffering and
Resource Saving (although default settings are usually best) or add
more memory to the printer.
/'/14;5*146#)'
,1$%.'#4'&
The printer did not have enough free memory to print the entire job.
The remainder of the job will not print and will be cleared from
memory.
Press [Go] to continue.
Change the Resource Saving setting from the printer’s control panel
or add more memory to the printer.
/'/14;5*146#)'
2#)'5+/2.+(+'&
The printer had to compress the job in order to fit it in available
memory. Some data loss might have occurred.
Press [Go] to continue.
You might want to add more memory to the printer.
1((.+0'
Press [Go] to place the printer online.
2'4(14/24+06'4
/#+06'0#0%'
To ensure optimum print quality, the printer prompts you to have
routine maintenance performed every 150,000 pages. Contact an
HP-authorized service or support provider to perform routine printer
maintenance. (See the HP Support pages at the front of this user’s
guide.)
4#/&+5-&'8+%'
(#+.74'
The RAM disk had a critical failure and can no longer be used.
Turn the printer off, and then turn the printer on to clear the message.
4#/&+5-(+.'
12'4#6+10(#+.'&
The requested operation could not be performed. You might have
attempted an illegal operation, such as trying to download a file to a
non-existent directory.
Printer Messages (Continued)
Message Explanation or Recommended Action
To Next Page
Loading...