142 Removing and replacing parts EN
Figure 44. Removing the top cover
3 Open the rear output bin, and then remove two screws (callout 1) from the top cover, near the top
of the bin.
4 Remove two more screws (callout 2) located under the top cover door.
Figure 45. Releasing tabs to lift the top cover
5 Squeeze the frame below the tab to release the top cover. It might be necessary to use a small
flat-blade screwdriver to release the tab inside the small hole.
6 Holding the output delivery assembly in place (located toward the rear of the printer), remove the
top cover.
2
2
2
1
To Next Page
Loading...