EN Chapter 6 Removing and replacing parts 149
Removing internal assemblies
Fuser
WARNING! Let the fuser assembly cool before removal.
1 If a duplexer is installed, remove it. If a duplexer is not installed, remove the tray 2 dust cover from
the rear of the printer by pulling from the bottom.
2 Remove the rear cover/rear output bin (page 145).
Figure 53. Unlocking the fuser assembly
3 Rotate the two blue levers on the fuser assembly up to the unlocked position.
4 Pull the fuser assembly straight out of the printer.
CAUTION To prevent damage to the fuser assembly, do not grasp the fuser by the black plastic diverter.
Hint When reinstalling the fuser assembly, be sure the blue levers are initially in the unlocked position. Make
sure the fuser assembly is seated fully before rotating the blue levers down into the locked position.
To Next Page
Loading...