154 Removing and replacing parts EN
Laser/scanner
Figure 59. Removing the laser/scanner
1 To remove the laser/scanner:
a Remove the rear right side cover (page 138).
b Remove the control panel (page 139).
c Remove the top cover (page 141).
The laser/scanner is on top of the printer, tilted toward the rear.
2 Unplug the three connectors (callout 1) as shown.
3 Remove the screw to disconnect the grounding cable (callout 2).
4 Remove the four recessed screws around the edges of the laser/scanner. Do not remove the
three small screws on the cover of the laser/scanner.
CAUTION Do not loosen the Allen screw on the rear of the scanner assembly.
5 Lift the laser/scanner straight up.
Hint When you replace the laser/scanner, be sure the black shutter interlock arm (callout 3) is resting on
top of the metal shutter plate.
2
2
1
2
2
3
2
To Next Page
Loading...