158 Removing and replacing parts EN
Main motor
Figure 62. Removing the main motor
1 To remove the main motor:
a Remove the rear right side cover (page 138).
b Remove the control panel (page 139).
c Remove the top cover (page 141).
d Remove the front right side cover (page 144).
2 While holding the main motor board, unplug the main motor connector (callout 1) on the right
front side of the printer.
3 Remove the three screws around the corners of the metal plate.
4 Remove the main motor from the printer.
2
1
To Next Page
Loading...