176 Removing and replacing parts EN
Paper-feed guide assembly
1 To remove the paper-feed guide assembly:
a Remove the rear right side cover (page 138).
b Remove the control panel (page 139).
c Remove the top cover (page 141).
d Remove the left side cover (page 143).
e Remove the front right side cover (page 144).
f Remove the rear cover/rear output bin (page 145).
g Remove the fuser assembly (page 149).
h Remove tray 1 (page 146).
i Remove the tray 1 pickup assembly (page 161).
j Remove the right side toner cartridge guide (page 164).
k Remove the registration assembly (page 165).
l Remove the formatter assembly (page 151).
m Remove the printer drive assembly (page 169).
n Separate the engine module from the paper-feed module (page 171).
o Remove the engine controller board (page 173).
2 Remove the plastic main gear cable guide by releasing the three tabs.
3 Loosen the plastic formatter ribbon cable guide.
4 Disconnect the paper-sensor cable.
5 Remove the two self-tapping screws.
6 Carefully remove the paper-feed guide assembly.
Note The engine controller board grounding spring might interfere with removal.
To Next Page
Loading...