216 Troubleshooting EN
68 NVRAM FULL
CHECK SETTINGS
An error occurred in the
printer’s NVRAM and one
or more printer settings
has been reset to its
factory default.
1. Print a configuration page and
check the printer settings to
determine which values have
changed.
2. Hold down C
ANCEL
J
OB
while
turning the printer on. This will
clean up the NVRAM by
removing old areas that are not
being used.
68.X PERMANENT
STORAGE ERROR
alternates with
CHECK SETTINGS
An error occurred in the
printer’s permanent
storage and one or more
printer settings has been
reset to its factory default.
Print a configuration page and
check the printer settings to
determine which values have
changed.
68.X PERMANENT
STORAGE FULL
The printer’s permanent
storage is full. Some
settings might have been
reset to the factory
defaults.
1. Print a configuration page and
check the printer settings to
determine which values have
changed.
2. Hold down
C
ANCEL
J
OB
while
turning the printer on. This will
clean up the permanent storage
by removing old areas that are
not being used.
69.X PRINTER ERROR
alternates with
CYCLE POWER TO
CONTINUE
A temporary printing error
occurred.
X description:
0 = The duplex mechanism
has failed
1. Turn the printer off, and then
turn the printer on.
2. Reseat the duplexer.
3. Replace the duplexer.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action
To Next Page
Loading...