HP 4100tn - LaserJet B/W Laser Printer - Page 224

222 Troubleshooting EN
Paper-path test
To perform a paper-path test:
1 Press M
ENU
until
INFORMATION MENU
appears.
2 Press I
TEM
until
PRINT PAPER PATH TEST
appears.
3 Press S
ELECT
.
INPUT=TRAY 1
is displayed
4 Press V
ALUE
+ to cycle selections until the desired paper tray appears.
5 Press S
ELECT
.
OUTPUT=TOP BIN
is displayed.
6 Press V
ALUE
+ until the desired output bin appears (open the rear output bin to print to it).
7 Press S
ELECT
.
DUPLEX=ON
is displayed. This selection only appears when a duplexer is installed.
8 Press V
ALUE
+ until the desired duplex mode (
ON
or
OFF
) appears.
9 Press S
ELECT
.
COPIES=1
appears.
10 Press V
ALUE
+ to cycle selections until the desired number of copies appears. Choose 1, 10, 50,
100, or 500 copies.
11 Press S
ELECT
to perform the paper-path test.
Information pages
From the printer control panel you can print pages that give details about the printer and its current
configuration. The following information pages are described here:
!
Menu map
!
Configuration page
For a complete list of the printer information pages, print a menu map and see the information menu.
Menu map
To see the current settings for the menus and items available on the control panel, print a control
panel menu map:
1 Press M
ENU
until
INFORMATION MENU
appears.
2 Press I
TEM
until
PRINT MENU MAP
appears.
3 Press S
ELECT
to print the menu map.
The content of the menu map varies, depending on the options currently installed in the printer. The
printer driver or software application can override many of these values.