84 Printer maintenance EN
Using the printer cleaning page
If toner specks appear on the front or back side of print jobs, follow the procedure below.
From the printer control panel, do the following:
1 Press M
ENU
until
PRINT QUALITY MENU
appears.
2 Press I
TEM
until
CREATE CLEANING PAGE
appears.
3 Press S
ELECT
to create the cleaning page.
4 Follow the instructions on the cleaning page to complete the cleaning process.
Note In order for the cleaning page to work correctly, print the page on copier-grade paper (not bond or
rough paper).
You might need to create and process a cleaning page more than once. When toner has been
cleaned from the fuser assembly, shiny black spots will appear on the page’s black strip. If white
spots appear on the black strip, create another cleaning page.
To ensure good print quality with certain types of paper, use the cleaning page every time the toner
cartridge is replaced. If the cleaning page is frequently needed, try a different type of paper.
Using the auto-cleaning page
The auto-cleaning page feature helps keep the fuser rollers clean, which maintains excellent output
quality. The auto-cleaning page feature is accessible through the control panel and is supported
through Web JetAdmin, as well. Once set up, the printer runs a cleaning page through the printer as
a separate job at the frequency requested with no further user intervention. The settings can be
changed or the feature can be turned off at any time.
Note Once the auto-cleaning page feature is enabled, the printer automatically pulls plain letter- or A4-sized
media from a tray. If the paper size or types are not available in the printer, a message appears in the
control panel display requesting the user to load media into the printer.
To override a paper load message, press G
O
, and then answer the questions on the control panel
display.
To set up the auto-cleaning page:
1 Press M
ENU
until
PRINT QUALITY MENU
appears.
2 Press I
TEM
until
AUTO CLEANING PAGE
appears.
3 Press V
ALUE
+ until
=ON
appears, and then press S
ELECT
.
4 Press V
ALUE
+ to select the auto cleaning frequency, and then press S
ELECT
.
5 Press I
TEM
until
CLEANING PAGE SIZE=LETTER
or
A4
, and then press V
ALUE
+ to select the paper
size to be used for cleaning.
6 Press S
ELECT
to save the auto-cleaning settings.
Note The auto cleaning page takes about 2.5 minutes to process.
To Next Page
Loading...