HP 4145A - Section III Operation; 3-1. Introduction

Model 4145A
SECTION III
3-l. INTRODUCTION
3-2. This section provides all the information
necessary to
operate the Model 4145A
Semiconductor Parameter Analyzer. Included
are descriptions of the front and rear panels,
graphics display, lamps, and connectors;
discussions on
operating procedures and
measuring techniques for typical applications;
and instructions on the instruments self-test
function and HP-IB capabilities. A breakdown of
the contents of this section is given in Figure
3-l. Warnings and cautions are given throughout;
they must be observed to insure operator safety
and continued instrument serviceability.
TO A PROTECTIVE EARTH-
GROUNDED SOCKET. ANY INTER-
RUPTION OF THE PROTECTIVE
EARTH GROUNDING WILL CAUSE A
POTENTIAL SHOCK HAZARD THAT
COULD RESULT IN SERIOUS
PERSONAL INJURY.
ONLY FUSES OF THE REQUIRED
RATED CURRENT AND OF THE
SPECIFIED TYPE SHOULD BE USED.
DO NOT USE REPAIRED FUSES OR
SHORTED FUSEHOLDERS. TO DO SO
CAN CAUSE A SHOCK OR FIRE
HAZARD.
WARNING CAUTION
BEFORE THE INSTRUMENT IS BEFORE THE INSTRUMENT IS
TURNED ON, ALL PROTECTIVE
TURNED ON, IT MUST BE SET TO
EARTH TERMINALS, EXTENSION THE VOLTAGE OF THE POWER
CORDS, AUTO-TRANSFORMERS AND somcx (MAINS), 0R DAMAGE ~0
DEVICES CONNECTED TO
THE
THE INSTRUMENT MAY RESULT.
INSTRUMENT MUST BE CONNECTED
we
Basic Operation
(paragraphs 3-3 through 3-39)
Graphics Display
(paragraphs 3-40 through 3-76)
Measurement Basics
(paragraphs 3-77 through 3-89)
Extended Capabilities
(paragraphs 3-90 through 3-l 26)
* HP-IB Capabilities
* PLOT Function
* PRINT Function
* External Display
* Disc Copy
* Head Cleaning
Figure 3-l. Contents of Section III.
3-l