HP 4145A - Page 40

Model 4145A
SECTION III
D USER FILE Keys :
@ MEASURING Lamp:
These keys are used to store program or
data files onto the disc or to recall them.
SAVE : Used to store the existing
measurement setup, mea-
surement result, or
auto-sequence program onto
the flexible disc. Press
SAVE, enter the file type (P
for a measurement setup, D
for a measurement result, S
for an auto-sequence
program),
file name, and
comment (if necessary), and
then press EXECUTE 0.
GET : Used to recall a measure-
ment setup, measurement
result, or auto-sequence
program from the flexible
disc.
Press GET, enter the
file type (P for a mea-
surement setup,
D for a
measurement result, S for an
auto-sequence program), and
file name, and then press
EXECUTE 0.
This lamp comes on when the 4145A is
measuring. When measurement is com-
pleted or when the STOP key is pressed, this
lamp goes off immediately.
@J CRT Adjustment :
INTENSITY determines the brightness of
traces displayed on the CRT. FOCUS
adjusts
the writing beam for sharp,
well-defined traces.
0
3 FLEXIBLE DISC DRIVE:
Accommodates a 92K byte, single-sided,
single-density, 5-l/4 inch flexible disc, and
functions as the 4145A’s mass storage unit
(MSU). The lamp, located in the upper
left-hand corner of the drive unit door,
comes on when the 4145A is reading data
from the disc. To open the door, press
firmly on the center of the door until an
audible click is heard, then release the
door. Refer to
paragraph 3-5 for
information on proper handling of the
flexible disc.
Figure 3-2. Front Panel Features (Sheet 6 of 6).
3-7