HP 4278A - Page 100

NOM= SOFTKEY LABEL: NOT ASSIGNED
The NOM= command is used to set the nominal value in the tolerance
mode.
SYNTAX:
VALUE:
)1
You cannot use units (for example: F), or a suffix (for example: p (pica),
with the nominal value.
EXAMPLE:
OUTPUT 717;"NOM=10E-12"
I Set the nominal value to 10pF.
OFFA= SOFTKEY LABEL: OFS A= (in 'OFFSET')
The OFFA= command is used to set the offset A data.
SYNTAX:
( OFFA=
value
VALUE:
You cannot use units (for example: F), or suffixes (for example: p
(pico)), with offset A data.
IMPORTANT POINTS:
Unit is F.
EXAMPLE:
OUTPUT 717;"OFFA=10E-12"ISet the offset A data to 10pF
4-35