HP 4278A - Page 97

ITI M
Control
Parameter
Description
1
2
3
Set the integration time to SHORT.
Set the integration time to MED.
Set the integration time to LONG.
Control
Parameter
Description
1
2
3
Set the limit mode to % TOL MODE.
Set the limit mode to ABS TOL MODE.
Set the limit mode to SEQ MODE.
SOFTKEY LABEL: SHORT/MED/LONG (in `MEAS TIME')
The ITIM command sets the integration time.
SYNTAX:
ITIM
PARAMETER:
control
The control parameter choices are:
The default setting is ITIM3.
EXAMPLE:
OUTPUT 717;"MM2"! Set the INTEG.TIME to MED
LMOD SOFTKEY LABEL: % TOL/ABS TOL/SEQ MODE (in 'COMPARATOR')
The LMOD command is used to set the limit mode.
SYNTAX:
PARAMETER:
The control parameter choices are:
The default setting is LMOD1.
EXAMPLE:
OUTPUT 717;"LMOD2"! Set the limit mode to ABS TOL MODE.
4-32