HP 4278A - Page 98

LOAD SOFTKEY LABEL: NOT ASSIGNED
Control
Parameter
Description
1 Set the limit parameter to Cp-D.
2 Set the limit parameter to Cp-Q.
3
Set the limit parameter to Cp-G.
4
Set the limit parameter to Cs-D.
5 Set the limit parameter to Cs-Q.
6 Set the limit parameter to Cs-Rs.
The LOAD command loads the setting conditions from the memory
card.
SYNTAX:
( LOAD )
EXAMPLE:
OUTPUT 717;"LOAD"I Load from the memory card.
LPAR SOFTKEY LABEL: Cp-D/Cp-Q/Cp-G/Cs-D/Cs-a/Cs-Rs (in 'COMPARATOR')
The LPAR command sets the limit parameter.
SYNTAX:
CLPAR
PARAMETER:
control
The control parameter choices are:
The default setting is LPAR1.
EXAMPLE:
OUTPUT 717;"1...PAR21 Set the limit parameter to Cp-Q.
4-33