Removal and replacement procedures
Maintenance and Service Guide 4–17
WWAN module
Before removing the WWAN module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, 
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then 
unplugging the AC adapter from the computer.
4. Remove the battery (see “Battery” on page 4-7).
5. Remove the memory/wireless module compartment cover (see “WLAN module” on page 4-12).
Remove the WWAN module:
Ä
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module authorized for use in the 
computer by the governmental agency that regulates wireless devices in your country or region. If you replace the module and 
then receive a warning message, remove the module to restore computer functionality, and then contact technical support through 
Help and Support.
1. Position the computer with the front toward you.
2. Disconnect the WWAN antenna cables 1 from the terminals on the WWAN module.
✎
The red WWAN antenna cable is connected to the WWAN module “Main” terminal. The blue 
WWAN antenna cable is connected to the WWAN module “Aux” terminal. 
3. Remove the two Phillips PM2.5×4.0 screws 2 that secure the WWAN module to the computer. (The WWAN 
module tilts up.)
4. Remove the WWAN module 3 by pulling it away from the slot at an angle. 
✎
WWAN modules are designed with a notch 4 to prevent incorrect insertion of the WWAN module into 
the WWAN module slot.
Reverse this procedure to install the WWAN module. 
Description Spare part number
HSPA EV-DO WWAN module for use in all countries and regions except 
the People’s Republic of China
483377-002
Telecom EV-DO CT1 WWAN module for use only in the People’s Republic of China 574246-001
Telecom EV-DO CT2 WWAN module for use only in the People’s Republic of China 582724-001