Removal and replacement procedures
Maintenance and Service Guide 4–31
b. Flex the inside edges of the top edge 1, the left and right sides 2, and the bottom edge 3 of the display
bezel until the bezel disengages from the display enclosure.
c. Remove the display bezel 4. The display bezel is available using the following spare part numbers:
◆ 577194-001—for use only on computer models equipped with a webcam
◆ 577195-001—for use only on computer models not equipped with a webcam
15. If it is necessary to replace the webcam module:
a. Remove the four Phillips PM2.5×4.0 screws 1 that secure the display panel to the display enclosure.
b. Remove the display panel cable from the clips 2 built into the display enclosure.
c. Remove the display panel 3.
To Next Page
Loading...
