HP 4395A - Manual Changes; Introduction; Table A-1. Manual Changes by Serial Number

A
Manual Changes
Introduction
This appendix contains the information required to adapt this manual to earlier versions or
congurations of the analyzer than the current printing date of this manual. The information
in this manual applies directly to the HP 4395A Network/Spectrum/Impedance Analyzer serial
number prex listed on the title page of this manual.
Manual Changes
To adapt this manual to your HP 4395A, see Table A-1 and Table A-2, and make all the manual
changes listed opposite your instrument's serial number and rmware version.
Instruments manufactured after the printing of this manual may be dierent from those
documented in this manual. Later instrument versions will be documented in a manual
changes supplement that will accompany the manual shipped with that instrument. If your
instrument's serial number is not listed on the title page of this manual or in T
able A-1, it may
be documented in a yellow MANUAL CHANGES supplement.
In additions to change information, the supplement may contain information for correcting
errors (Errata) in the manual. To keep this manual as current and accurate as possible
,
Hewlett-Packard recommends that you periodically request the latest MANUAL CHANGES
supplement.
For information concerning serial number prexes not listed on the title page or in the
MANUAL CHANGE supplement, contact the nearest Hewlett-Packard oce.
Turn on the line switch or execute the *IDN? command by HP-IB to conrm the rmware
version. See the HP-IB Command Reference manual for information on the *IDN? command.
Table A-1. Manual Changes by Serial Number
Serial Prex or Number Make Manual Changes
JPIKE00275 or below Change 1
Table A-2. Manual Changes by Firmware Version
Version Make Manual Changes
Manual Changes A-1