HP 4395A - Page 299

Error Messages in Alphabetical Order
137 DC CURRENT LIMIT OCCURED
The output current at DC SOURCE port is reached to an upper limit and the output voltage is
reduced so that the current does not exceed the upper limit. This message appears when the
DC SOURCE port is used in voltage control mode.
136 DC SOURCE OVERLOAD
The DC SOURCE output is overloded.
138 DC VOLTAGE LIMIT OCCURED
The output voltage at DC SOURCE port is reached to an upper limit and the output current is
reduced so that the voltage does not exceed the upper limit. This message appears when the
DC SOURCE port is used in current control mode.
37 DISPLAY BUFFER IS FULL
The display buer is lled with the overlay traces or traces drawn by IBASIC DRAW/MOVE
commands, etc.
117 DUPLICATE FILE EXTENSION
The extension name entered is already used for other le types
. Use other extension name.
E
15 EXCEEDED 7 STANDARDS PER CLASS
A maximum of seven standards can be dened for any class
.
0 200 Execution error
This is the generic syntax error that the analyzer cannot detect more specic errors
. This code
indicates only that an execution error as dened in IEEE 488.2, 11.5.1.1.5 has occurred.
0 123 Exponent too large
The magnitude of the exponent was larger than 32000 (see IEEE 488.2, 7.7.2.4.1).
F
0 257 File name error
Indicates that a legal program command or query could not be executed because the le name
on the device media was in error.For example, an attempt was made to copy to a duplicate le
name. The denition of what constitutes a le name error is device-specic.
0 256 File name not found
A legal program command could not be executed because the le name on the device media
was not found: for example, an attempt was made to read or copy a nonexistent le.
Messages-5