HP 4430 User Manual

One Blue Hill Plaza, 16
th
Floor, PO Box 1546
Pearl River, NY 10965
1-800-PC-AMERICA, 1-800-722-6374
(Voice) 845-920-0800 (Fax) 845-920-0880
HP 4430 2D Imaging Barcode Scanner
This document contains barcodes for resetting the HP USB Barcode Scanner to factory defaults and for
simulating a carriage return (pressing the Enter key). You can also configure the barcode scanner to
scan Driver Licenses.
Note: This barcode scanner has to ability to scan barcodes directly from a computer screen.
HP Part Number: BW868AA

HP 4430 Specifications

General

Scan Engine	Laser
Scan Pattern	Single line
Scan Rate	100 scan/s
Interface	USB
Supported Barcodes	Code 39, Code 128, Interleaved 2 of 5, Codabar, MSI, Code 93, GS1 Databar, PDF417, MicroPDF417, QR Code, Data Matrix, Aztec, MaxiCode
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-20 to 60° C (-4 to 140° F)
Humidity	5% to 95% (non-condensing)
Drop Specification	1.5 m (5 ft) to concrete
Light Source	LED

Summary

Resetting the HP 2D Imaging Barcode Scanner to Factory Defaults

Set All Defaults Barcode

Barcode to reset all scanner parameters to factory defaults.

Simulating Carriage Return (Enter Key)

Enter Programming Mode Barcode

Barcode to enter programming mode for simulating carriage return.

Set Global Suffix Barcode

Barcode to set a global suffix for carriage return.

Programming Mode Sequence

Sequence of barcodes to configure programming mode for carriage return.

Exit Programming Mode Barcode

Barcode to exit programming mode.

Driver License Configuration Barcodes

Enter Driver License Configuration

Barcode to initiate driver license configuration.

Advanced Formatting and Label Edit Script

Barcode to enable advanced formatting and label edit script.

Driver License Data Lines

Barcodes representing data lines for driver license configuration.

Exit Driver License Configuration

Barcode to exit driver license configuration.

Scanner Modes and Configuration

Enable Stand Mode

Barcode to enable stand mode for automatic sensing and reading.

CRE/RPE Configuration

Steps to enable CRE/RPE for specific ID scanners.