Control panel message Description Recommended action
Ready
TRAY XX OPEN
For help press
alternates with
Ready
The tray is open, but printing can continue. Close the tray.
TRAY XX OPEN OR EMPTY
alternates with
Ready
The tray is open or empty, but the current
print job does not require this tray.
Close or fill the tray.
TYPE MISMATCH IN TRAY XX
alternates with
Ready
The tray is loaded with a media type that is
different than the type for which the tray is
configured. Printing can continue from other
trays, but not from this one.
In the PAPER HANDLING menu, configure
the tray for the correct type.
Unauthorized supply in use
alternates with
Ready
The printer has detected that a non-
HP supply is currently installed and
(override) was pressed.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs required as a result of using
non-HP supplies are not covered under
HP warranty.
USE TRAY X <TYPE> <SIZE>trays The printer is offering a selection of alternate
media to use for the print job.
1.
Use
and to highlight a different
size or type, and then press
to select
the size or type.
2.
Press
to return to the previous size
or type.
See
Configuring trays on page 53 for more
information.
114 Chapter 7 Problem solving ENWW
To Next Page
Loading...