HP 5200dtn - LaserJet B/W Laser Printer - Page 147

4. Open the CONFIGURE DEVICE menu at the printer control panel. Open the PRINT QUALITY
submenu and change the TONER DENSITY setting. (See
Print Quality submenu on page 27.)
5. Open the CONFIGURE DEVICE menu at the printer control panel. On the PRINT QUALITY
submenu, open OPTIMIZE and set LINE DETAIL=ON.
Blurred print
1. Make sure that the type and quality of the media you are using meet HP specifications. (See Paper
specifications on page 160.)
2. Make sure that the environmental specifications for the printer are being met. (See
Operating
environment on page 159.)
3. Turn over the stack in the tray. Also, try rotating the stack 180°.
4. Do not use media that already has been run through the printer.
5. Decrease the toner density. Open the CONFIGURE DEVICE menu at the printer control panel.
Open the PRINT QUALITY submenu and change the TONER DENSITY setting. (See
Print Quality
submenu on page 27.)
6. Open the CONFIGURE DEVICE menu at the printer control panel. On the PRINT QUALITY
submenu, open OPTIMIZE and set HIGH TRANSFER=ON. (See
Print Quality submenu
on page 27.)
Random image repetition
ENWW Troubleshooting print-quality problems 135