Label construction
When selecting labels, consider the quality of each component:
●
Adhesives: The adhesive material should be stable at 200°C (392°F), which is the printer fusing
temperature.
●
Arrangement: Only use labels with no exposed backing between them. Labels can peel off sheets
with spaces between the labels, causing serious jams.
●
Curl: Prior to printing, labels must lie flat with no more than 13 mm (0.5 in) of curl in any direction.
●
Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
For more information, see
Printing on labels on page 61.
NOTE: Choose labels in the printer driver (see Printer drivers on page 7).
Transparencies
Transparencies used in the printer must be able to withstand 200°C (392°F), which is the printer fusing
temperature.
CAUTION: To avoid damaging the printer, use only transparencies recommended for use in
HP LaserJet printers, such as HP-brand transparencies. (For ordering information, see
Part numbers
on page 145.)
For more information, see Printing on transparencies on page 61.
NOTE: Choose transparencies in the printer driver (see Printer drivers on page 7).
162 Appendix C Specifications ENWW
To Next Page
Loading...