Selecting the language during initial installation
1. Turn on the printer.
2. When LANGUAGE appears on the control-panel display in the default language, press
to
highlight the preferred language, and then press
.
Changing the language after the initial configuration
After the initial installation, you can change the control-panel display language from the control panel.
1. Press Menu.
2. Use
to highlight CONFIGURE DEVICE, and then press
3. Use to highlight SYSTEM SETUP, and then press
4. Use to highlight LANGUAGE, and then press
5. Use or to highlight the appropriate language, and then press .
6. Press Menu to exit the menu.
42 Chapter 2 Control panel ENWW
To Next Page
Loading...