3. Slide the media-width guides slightly wider than the media.
4. Place media into the tray (short-edge in, print-side up). The media should be centered between
the media-width guides and under the tabs on the media-width guides.
5. Slide the media-width guides inward until they lightly touch the media stack on both sides without
bending it. Make sure that the media fits under the tabs on the media-width guides.
NOTE: Do not add media to tray 1 while the printer is printing. This could cause a jam. Do not close
the front door when the printer is printing.
Customizing tray 1 operation
The printer can be set to print from tray 1 if it is loaded, or to print only from tray 1 if the type of media
that is loaded is specifically requested. See
Paper Handling menu on page 23.
54 Chapter 4 Printing tasks ENWW
To Next Page
Loading...