5. Adjust the guides to touch the envelope stack without bending the envelopes. Make sure that the
envelopes fit under the tabs on the guides.
Printing on labels
Use only labels that are recommended for laser printers. For label specifications, see Labels
on page 161.
Guidelines for printing on labels
●
Print labels from tray 1. Load them with the side to be printed on facing up and the top edge to the
right.
●
Use the rear output bin for labels.
●
Remove label sheets from the output bin as they are printed to prevent them from sticking together.
●
Do not use labels that are separating from the backing sheet or are wrinkled or damaged in any
way.
●
Do not use label sheets that have the backing sheet exposed, and do not reuse partially used label
sheets.
●
Do not feed a sheet of labels through the printer more than once. The adhesive backing is designed
for one pass through the printer.
●
Do not print on both sides of labels.
CAUTION: Failure to follow these guidelines can damage the printer.
If a sheet of labels becomes jammed in the printer, see
Clearing jams on page 119.
Printing on transparencies
Use only transparencies that are recommended for use in laser printers. For transparency specifications,
see
Transparencies on page 162.
Guidelines for printing on transparencies
●
Print transparencies from tray 1. Load them with the side to be printed on facing up and the top
edge to the right.
●
Use the top output bin to reduce curling (this is for transparencies only; for other media use the
rear output bin to reduce curling).
ENWW Printing on special media 61
To Next Page
Loading...