HP 5400 zl

2-7
Installing the HP 5400 zl Switches
Installation Procedures
Installing the HP 5400 zl
Switches
■ Once the module is fully inserted, screw in the two retaining screws to
secure the module in place. The screws should be tightened until they are
secure, but not overtightened.
■ If you do not use one or more of the slots, ensure the slot cover plate is
still attached over the slot for safe operation and proper switch cooling.
For safety, you should not have more than one module slot uncovered at
a time.
■ Although these procedures show the 6-slot chassis, the procedures are
the same for the 12-slot chassis.
Figure 2-1. Module being installed in a chassis
Insert module into the guides and
slide it in until it is fully inserted.
Open extractor handles