How to check the port configuration on HP ProCurve 5400zl?
Use the switch console to determine the port’s configuration and verify that there is not an improper or undesired configuration of any of the switch features that may be affecting the port. A port may not be operating as expected because it has been put into a blocking state.
How to restore the factory default configuration on HP ProCurve 5400zl?
To restore the factory default configuration: * Simultaneously press both the Reset and Clear buttons on the front of the switch using pointed objects. * As soon as the Test LED begins to flash, release the Clear button. You can also execute the erase startup config command from the console command prompt.
What to do if the network connection is not working properly on my HP Switch?
If your network connection isn't working properly, start by verifying that both ends of the cabling are securely connected and that the connected device and the switch are powered on and operating correctly. Also, verify that you're using the correct cable type for the connection and that the port hasn't been disabled through a switch configuration change.
What to do if the power supplies installed in the HP ProCurve 5400zl Switch are not working?
First, verify that the power cord is plugged into an active power source and connected securely to the switch. If that doesn't solve the problem, try power cycling the switch by unplugging it and plugging it back in. If the Power LED is still not on after these steps, further assistance is needed.
Why is the Link LED blinking on my HP Switch port and how to fix it?
The network port's Link LED may be blinking because port security has been configured on the switch and a security violation has been detected on the port. If a port is disabled this way, the port Link LED will flash rapidly. To resolve this, clear the security violation through the switch console and re-enable the port.
What to do if I have improper network topologies with my HP ProCurve 5400zl Switch?
Make sure you have a valid network topology. If network problems occur after recent changes, revert to the previous topology. If the problems disappear, the new topology is likely the cause.
What to do if the module installed in the HP ProCurve 5400zl Switch is an invalid module?
Ensure you have installed a zl module in the slot. If the installed module is a ProCurve Switch xl/gl module, remove it and replace it with a zl module, or recover the slot with the cover plate.
What to do if I have faulty or loose cables with my HP ProCurve 5400zl Switch?
Inspect for loose or obviously faulty connections. If they appear to be OK, ensure the connections are snug. If the issue persists, try using a different cable.
What to do if the module installed in the HP ProCurve 5400zl Switch has experienced a self test fault?
Verify the switch has a version of code that supports the module that is indicating the fault. You can also try removing and reinstalling the module.
What to do if I have non-standard cables with my HP Switch?
Use a new, correctly-wired cable, or compare your cable to the cable in appendix B for pinouts and correct cable wiring. A category 5 cable tester is a recommended tool for every 100Base-TX and 1000Base-T network installation.
General| Model | 5400zl |
|---|---|
| Product Series | ProCurve |
| Layer | Layer 3 |
| VLAN Support | Yes |
| Jumbo Frame Support | Yes |
| Quality of Service (QoS) | Yes |
| Product Type | Switch |
| Management | Web, CLI, SNMP |
| Power over Ethernet (PoE) | Yes |
| Stacking | Yes |
| Power Supply | Redundant |
| Layer 3 Routing | Yes |
| Security Features | ACLs, RADIUS, TACACS+ |
| Operating Temperature | 0°C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Form Factor | Modular chassis |
To Next Page
