HP ProCurve 5400zl

redundancy
OVERVIEW
Category:
managerPrimary context:
Related Commands
Usage: redundancy switchover
redundancy active-management < management-module1 |
management-module2 |
standby>
Description: Redundancy conguration for management modules.
The rst version of the command causes the switch to
immediately switchover to the standby management module.
The second version of the command makes the module specied
an active management module for next boot. This command
will fail if the other module is in a failed state.
NOTES
Multiple Contexts
This command also is available in the config context.
COMMAND STRUCTURE
■ redundancy active-management < management-module1 | management-module2 | standby >
-- Specify the management module that will be active for next boot. (NUMBER) (p. 466)
■ redundancy switchover -- Switchover to the standby management module. (p. 466)
COMMAND DETAILS
switchover (p. 466)active-management (p. 466)
active-management
■ redundancy active-management < management-module1 | management-module2 | standby >
Specify the management module that will be active for next boot.
Supported Values:
■ management-module1 -- Configures management-module 1 as an active management module
for next boot
■ management-module2 -- Configures management-module 2 as an active management module
for next boot
■ standby -- Configures standby module as an active management module for next boot
switchover
■ redundancy switchover
Switchover to the standby management module.
466© 2009 Hewlett-Packard Development Company, L.P.