EasyManuals Logo

HP ProCurve 5400zl User Manual

HP ProCurve 5400zl
765 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #458 background imageLoading...
Page #458 background image
radius-server
OVERVIEW
Switch SecurityCategory:
configPrimary context:
show radius (page 583)Related Commands
Usage: [no] radius-server host <IP-ADDR>
[auth-port <UDP-PORT>]
[acct-port <UDP-PORT>]
[dyn-authorization]
[time-window <0-65535>]
[key <KEY-STR>]
[no] radius-server key <KEY-STR>
radius-server timeout <1-15>
radius-server retransmit <1-5>
radius-server dyn-autz-port <UDP-PORT>
[no] radius-server dead-time <1-1440>
Description: Congure RADIUS parameters.
The rst command adds/removes a RADIUS server to/from the
list of the RADIUS servers that will be used for the
authentication, accounting and authorization. Up to 3 RADIUS
servers can be congured.
The second command sets/removes the global encryption key to use
in communication with RADIUS servers.
The third command sets the interval in seconds the switch
waits for a reply from a RADIUS server.
The fourth command species the number of times the switch
retransmits requests to a RADIUS server.
The fth command species the UDP port to listen for
Change-of-Authorization and Disconnect messages.
The last command sets the length of time in minutes a RADIUS
server that failed to respond to an authentication request is
bypassed by additional requests. See 'dead-time', below. Use
the 'no' form of command to set the dead-time to 0.
Parameters:
o host IP-ADDR [auth-port <UDP-PORT>] [acct-port <UDP-PORT>]
[dyn-authorization] [time-window <0-65535>]
[key <KEY-STR>] - species
the IP address of the RADIUS server to use. Optional parameter
'auth-port <UDP-PORT>' species the UDP destination port to use
when sending authentication requests to the server (default is
1812). Optional parameter 'acct-port <UDP-PORT>' species the
UDP destination port to use when sending accounting requests to
the server (default is 1813). Optional 'dyn-authorization'
parameter enables/disables the processing of Disconnect and
Change-of-Authorization messages from the host. Optional
parameter 'time-window <0-65535>' species the time frame
(in seconds) within which received Change-of-Authorization and
Disconnect request messages will be considered current and
accepted for processing, '0' value means 'innity' (default is
300 seconds). Optional parameter 'key <KEY-STR>' species an
456© 2009 Hewlett-Packard Development Company, L.P.

Table of Contents

Other manuals for HP ProCurve 5400zl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 5400zl and is the answer not in the manual?

HP ProCurve 5400zl Specifications

General IconGeneral
BrandHP
ModelProCurve 5400zl
CategorySwitch
LanguageEnglish

Related product manuals