HP ProCurve 5400zl

telnet-server
OVERVIEW
Switch ManagementCategory:
configPrimary context:
the section called “console” (page 543)Related Commands
Usage: [no] telnet-server
Description: Enable/disable telnet server on the switch.
For remote clients to use telnet, the switch must rst be
congured for IPv4. By default, telnet access is enabled.
Use 'show console' command to see the status of this function.
COMMAND STRUCTURE
EXAMPLES
Example: telnet-server
Re-enable inbound Telnet access:
ProCurve(cong)# telnet-server
683© 2009 Hewlett-Packard Development Company, L.P.