HP ProCurve 5400zl

traceroute
OVERVIEW
Switch ManagementCategory:
operatorPrimary context:
ping (page 392)Related Commands
Usage: traceroute <IP-ADDR|hostname> [minttl <1-255>]
[maxttl <1-255>] [timeout <1-120>]
[probes <1-5>]
[source <IP_ADDR|VLAN-ID>]
Description: Trace the IPv4 route to a device on the network.
Parameters:
o IP-ADDR - IPv4 address of device to which to send traceroute.
o hostname - Hostname of device to which to send IPv4 traceroute.
o [minttl <1-255>] - Minimum number of hops used in outgoing probe
packets. The default value is 1.
o [maxttl <1-255>] - Maximum number of hops used in outgoing probe
packets. The default value is 30.
o [timeout <1-120>] - Time (in seconds) to wait for a response to a
probe. The default value is 5 seconds.
o [probes <1-5>] - Number of probe queries to send out for each hop.
The default value is 3.
o [source <IP_ADDR|VLAN-ID>] - The source IPv4 address or VLAN.
Examples:
(1) hp-switch# traceroute 1.1.1.1
COMMAND STRUCTURE
■ traceroute host-name -- Hostname of the destination device. (ASCII-STR) (p. 691)
■ maxttl < 1 to 255 > -- Maximum time to live <1-255>. (p. 692)
■ minttl < 1 to 255 > -- Minimum time to live <1-255>. (p. 692)
■ probes < 1 to 5 > -- Number of Probes <1-5>. (p. 692)
■ timeout < 1 to 120 > -- Traceroute timeout in seconds <1-120>. (p. 693)
■ traceroute ip-addr -- Destination IPv4 address. (IP-ADDR) (p. 691)
■ maxttl < 1 to 255 > -- Maximum time to live <1-255>. (p. 692)
■ minttl < 1 to 255 > -- Minimum time to live <1-255>. (p. 692)
■ probes < 1 to 5 > -- Number of Probes <1-5>. (p. 692)
■ timeout < 1 to 120 > -- Traceroute timeout in seconds <1-120>. (p. 693)
■ traceroute source -- Source address or VLAN. (p. 693)
■ ip-addr -- Source IPv4 address. (IP-ADDR) (p. 691)
■ maxttl < 1 to 255 > -- Maximum time to live <1-255>. (p. 692)
■ minttl < 1 to 255 > -- Minimum time to live <1-255>. (p. 692)
690© 2009 Hewlett-Packard Development Company, L.P.