To Next Page

To Previous Page

■ [no] lldp enable-notification -- Set the port for which notification should be enabled ([ethernet]

PORT-LIST) (p. 356)

■ lldp fast-start-count < 1 to 10 > -- Set MED fast-start count in seconds (NUMBER) (p. 357)

■ lldp holdtime-multiplier < 2 to 10 > -- Set holdtime-multipler between <2-10>; the default is 4

(NUMBER) (p. 357)

■ lldp refresh-interval < 5 to 32768 > -- Set refresh interval/transmit-interval in seconds (NUMBER)

(p. 358)

■ [no] lldp run -- Start or Stop LLDP on device (p. 358)

■ [no] lldp top-change-notify -- Set the port for which LLDP MED topology notification should be

enabled ([ethernet] PORT-LIST) (p. 359)

COMMAND DETAILS

medPortLocation (p. 357)COUNTRY (p. 356)addr (p. 353)

medTlvEnable (p. 357)dot1TlvEnable (p. 356)admin-status (p. 353)

omodes (p. 358)dot3TlvEnable (p. 356)auto (p. 353)

radio-ports (p. 358)elin-addr (p. 356)auto-provision (p. 353)

refresh-interval (p. 358)enable-notification (p. 356)auto-vlan (p. 354)

run (p. 358)fast-start-count (p. 357)basicTlvEnable (p. 354)

top-change-notify (p. 359)holdtime-multiplier (p. 357)CA-TYPE (p. 354)

vlan-base (p. 359)ipAddrEnable (p. 357)CA-VALUE (p. 354)

vlan-name (p. 359)lldp-ip (p. 357)civic-addr (p. 355)

WHAT (p. 359)lldp-ipv6 (p. 357)config (p. 355)

addr

■ lldp config [ETHERNET] PORT-LIST medPortLocation elin-addr OCTET-STR

Specify the Location name to be advertised.

admin-status

■ lldp admin-status [ETHERNET] PORT-LIST

Usage: lldp admin-status <port-list> <txonly | rxonly

tx_rx | disable>

Description: Set the port in one of the operational mode

transmit | receive | transmit & receive |

disable the port.

Next Available Option:

transmit-receive | disable. (NUMBER) (p. 358)

auto

■ lldp auto-provision radio-ports auto-vlan < 2 to 4094 > auto

auto-provision

■ lldp auto-provision

Usage:[no] lldp auto-provision radio-ports [suggested-auto-vlan|auto-vlan]

<vid>

lldpCommand Line Interface Reference Guide

HP ProCurve 5400zl User Manual

Other manuals for HP ProCurve 5400zl