Usage:[no] lldp run
Description: Start or Stop LLDP on device.
top-change-notify
■ [no] lldp top-change-notify [ETHERNET] PORT-LIST
Usage:[no]
lldp
top-change-notify
<port-list>
Description: Set the port for which LLDP MED topology notication should be enabled.
vlan-base
■ lldp auto-provision radio-ports vlan-base < 2 to 4094 >
Assign the default value of the VLAN id to be used if an
auto-generated VLAN is created for a radio-port application.
Range: < 2 to 4094 >
vlan-name
■ [no] lldp config [ETHERNET] PORT-LIST dot1TlvEnable vlan-name
Specify that the VLAN name TLV is to be advertised.
WHAT
■ lldp config [ETHERNET] PORT-LIST medPortLocation civic-addr COUNTRY NUMBER
Specify the 'what' number of range <0-2>.
Next Available Option:
■ CA-TYPE -- Specify the ca-type value of range <0-255>. (NUMBER) (p. 354)
359© 2009 Hewlett-Packard Development Company, L.P.
lldpCommand Line Interface Reference Guide
To Next Page
Loading...
