auto-tftp
OVERVIEW
File TransferCategory:
configPrimary context:
the section called “client” (page 685)Related Commands
Usage: [no] auto-tftp [<IPV4-ADDR | IPV6-ADDR> <FILENAME-STR>]
Description: Enable/disable automatic software image download via TFTP during
boot. The software image will be downloaded if it has a different
version from the software running on the switch. The command
requires the parameters to be specied when used without 'no'.
o IPV4-ADDR - species the TFTP server IPv4 address to download
a software image from.
o IPV6-ADDR - species the TFTP server IPv6 address to download
a software image from.
o FILENAME-STR - species the le-name to download.
COMMAND STRUCTURE
■ auto-tftp server-ip -- IPv4 address of the TFTP server to download a software image from. (IP-ADDR)
(p. 70)
■ filename -- The software image file-name. (ASCII-STR) (p. 70)
■ auto-tftp server-ipv6 -- IPv6 address of the TFTP server to download a software image from.
(IPV6-ADDR) (p. 71)
■ filename -- The software image file-name. (ASCII-STR) (p. 70)
EXAMPLES
Example: auto-tftp IP-ADDR FILENAME
Set the device to boot using image2 located on TFTP server 10.10.2.40, if the image version is different
from the one already on the switch:
ProCurve(cong)# auto-tftp 10.10.2.40 image2
COMMAND DETAILS
server-ipv6 (p. 71)server-ip (p. 70)filename (p. 70)
filename
■ auto-tftp IP-ADDR FILENAME
The software image le-name.
■ auto-tftp IPV6-ADDR FILENAME
The software image le-name.
server-ip
■ auto-tftp IP-ADDR
70© 2009 Hewlett-Packard Development Company, L.P.
To Next Page
Loading...
Need help?
General