HP ProCurve 5400zl

reload
OVERVIEW
Switch ManagementCategory:
managerPrimary context:
boot (page 73)Related Commands
Usage: [no] reload <after <[[DD:]HH:]MM> |
at HH:MM[:SS] [MM/DD[/[YY]YY]>] >
Description: Warm reboot of the switch. If no parameters are entered,
an immediate reload is executed.
[no] - Causes the removal of any pending reload request.
Note: The maximum allowable time is 99 days.
Parameters:
o after - Warm reboot the switch after the given amount of
time has passed.
o at - Warm reboot the switch at the given time.
COMMAND STRUCTURE
■ reload after -- Warm reboot in a specified amount of time. ([[DD:]HH:]MM) (p. 467)
■ reload at -- Warm reboot at a specified time; If the mm/dd/yy is left blank, the current day is
assumed. (p. 468)
■ time -- Time on given date to do a warm reboot. (HH:MM[:SS]) (p. 468)
■ date -- Date on which a warm reboot is to occur. (MM/DD[/[YY]YY]) (p. 468)
EXAMPLES
Example: reload
Automatically save your configuration changes and reboot the switch from the same flash image
you have been using:
ProCurve(cong)# max-vlans 12
Command will take effect after saving conguration and reboot.
ProCurve(cong)# reload
Device will be rebooted, do you want to continue [y/n]? y
Do you want to save current conguration [y/n]? y
COMMAND DETAILS
date (p. 468)after (p. 467)
time (p. 468)at (p. 468)
after
■ reload after [[DD:]HH:]MM
Warm reboot in a specied amount of time.
467© 2009 Hewlett-Packard Development Company, L.P.