HP ProCurve 5400zl

cdp
OVERVIEW
RoutingCategory:
configPrimary context:
the section called “cdp” (page 537)Related Commands
Usage: [no] cdp ...
Description: Set various CDP (Cisco Discovery Protocol) parameters. Use
'cdp ?' to get a list of all possible options.
COMMAND STRUCTURE
■ [no] cdp enable -- Enable/disable CDP on particular device ports ([ethernet] PORT-LIST) (p. 76)
■ [no] cdp run -- Start and stop CDP on the device (p. 76)
EXAMPLES
Example: cdp enable PORT-LIST
Disable CDP on port A1 of a Series 5400zl switch:
ProCurve(cong)# no cdp enable a1
Example: cdp run
Disable CDP on the switch:
ProCurve(cong)# no cdp run
COMMAND DETAILS
run (p. 76)enable (p. 76)
enable
■ [no] cdp enable [ETHERNET] PORT-LIST
Usage: [no] cdp enable [ethernet] PORT-LIST
Description: Enable/disable CDP on particular device ports.
run
■ [no] cdp run
Usage: [no] cdp run
Description: Start and stop CDP on the device.
76© 2009 Hewlett-Packard Development Company, L.P.