HP ProCurve 5400zl

sflow
OVERVIEW
Category:
configPrimary context:
Related Commands
Usage: sow <RECEIVER-INSTANCE> destination <IP-ADDRESS> [UDP-PORT]
sow <RECEIVER-INSTANCE> polling [ethernet] PORT-LIST
<POLLING-INTERVAL>
sow <RECEIVER-INSTANCE> sampling [ethernet] PORT-LIST
<SAMPLING-RATE>
[no] sow <RECEIVER-INSTANCE>
Description: Congure or un-claim an sow sampling receiver.
If the [no] option is not used, this command will
congure the sow sampling receiver, polling,
and sampling.
Parameters: IP-ADDRESS - Ip address of the sFlow
receiver/collector/management station
UDP-PORT - The udp application port of the sFlow
receiver/collector/management station (default: 6343).
POLLING-INTERVAL - The maximum interval (seconds) between
polling of counters. (a value of 0 causes polling to be
disabled.
PORT-LIST - Port(s) for which packet are to be sampled.
RECEIVER-INSTANCE - One of three posible sFlow receiver tables.
SAMPLING-RATE - N, where 1/N is the number of packets sampled.
(a value of 0 causes sampling to be disabled.)
COMMAND STRUCTURE
■ [no] sflow sflow-receiver < 1 to 3 > -- Select one of three possible sFlow receiver tables. (NUMBER)
(p. 510)
■ destination -- IP address of sFlow receiver/collector/management station. (IP-ADDR) (p. 509)
■ sflow-udp-port < 1 to 65535 > -- UDP application port of sFlow
receiver/collector/management station. (NUMBER) (p. 510)
■ polling -- Specify the ports for which packets are to be polled. ([ethernet] PORT-LIST) (p. 509)
■ sflow-polling-interval < 20 to 2147483647 > -- Specify the maximum interval (seconds)
between polling of counters. (p. 509)
■ sflow-polling-int-off < 0 > -- Disable polling of counters. (p. 509)
■ sampling -- Specify the ports for which packets are to be sampled. ([ethernet] PORT-LIST) (p.
509)
■ sflow-sampler-off < 0 > -- Disable sampling. (p. 510)
■ sflow-sampler-rate < 50 to 16441700 > -- Specify N, where 1/N is the number of packets
sampled. (p. 510)
508© 2009 Hewlett-Packard Development Company, L.P.