sflow-receiver
■ [no] sflow < 1 to 3 >
Select one of three possible sFlow receiver tables.
Range: < 1 to 3 >
Next Available Options:
■ destination -- IP address of sFlow receiver/collector/management station. (IP-ADDR) (p. 509)
■ polling -- Specify the ports for which packets are to be polled. ([ethernet] PORT-LIST) (p. 509)
■ sampling -- Specify the ports for which packets are to be sampled. ([ethernet] PORT-LIST) (p.
509)
sflow-sampler-off
■ sflow < 1 to 3 > sampling [ETHERNET] PORT-LIST < 0 >
Disable sampling.
Supported Values:
■ 0 -- Disable sampling.
sflow-sampler-rate
■ sflow < 1 to 3 > sampling [ETHERNET] PORT-LIST < 50 to 16441700 >
Specify N, where 1/N is the number of packets sampled.
Range: < 50 to 16441700 >
sflow-udp-port
■ sflow < 1 to 3 > destination IP-ADDR < 1 to 65535 >
UDP application port of sFlow receiver/collector/management station.
Range: < 1 to 65535 >
510© 2009 Hewlett-Packard Development Company, L.P.
sflowCommand Line Interface Reference Guide
To Next Page
Loading...
