Need help?Do you have a question about the HP ProCurve 5308xl and is the answer not in the manual?
General| Model | HP ProCurve 5308xl |
|---|---|
| Switching Capacity | 256 Gbps |
| MAC Address Table Size | 32, 000 entries |
| Ports | 8 |
| Management | Web, CLI, SNMP |
| Routing Protocol | RIP, OSPF, BGP |
| Features | VLAN support, QoS |
| Operating Temperature | 0°C to 50 °C |
| Operating Humidity | 15% to 95% non-condensing |
| Port Type | 10/100/1000BASE-T |
Guides through the physical setup and initial network connection of the switch.
Details how static VLANs function, including port-based and protocol-based types.
Provides steps for configuring VLANs using menu and CLI interfaces.
Covers default, primary, secure management, and voice VLAN configurations.
Details the steps for enabling, disabling, and configuring GVRP globally and per port.
Covers IGMP configuration and status checks using the Command Line Interface.
Explains the Forced Fast-Leave feature for optimizing multicast traffic.
Explains how PIM-DM handles multicast traffic forwarding and pruning.
Details the CLI commands for configuring PIM-DM globally and per VLAN.
Guides on optimizing RSTP configuration, including port and global parameters.
STP mode for faster access.
STP for uplink recovery.
Outlines the general steps for configuring MSTP, including region identity and instance parameters.
Covers troubleshooting common MSTP issues like duplicate packets.
Provides steps for configuring switch meshing using CLI and menu interfaces.
Explains QoS classifiers and their precedence for prioritizing traffic.
Details how to configure QoS priorities using various classifiers like UDP/TCP port, IP address, and VLAN ID.
Guides on designing ACLs for optimum network usage and performance.
Explains how ACLs enhance network security by blocking unauthorized traffic.
Guides on planning ACL strategy considering resource usage.
Addresses issues with insufficient ACL resources.
Provides steps for creating, configuring, and assigning ACLs.
Details how to enable logging for deny actions in ACLs.
Guides on configuring IP addresses, router ID, and ARP.
How to add and manage static IP routes.
Steps for configuring RIP, including parameters and redistribution.
Guides on configuring OSPF, including areas, parameters, and redistribution.
Details the fail-over process in single and multiple VLAN scenarios.
Steps for configuring XRRP globally and per instance.
Steps to configure stack management, including Commander and member setup.
Views and configures stacking using CLI commands.
Steps to configure a switch as a stack Commander.
To Next Page