Stack Management for the Series 3400cl and 6400cl Switches
Configuring Stack Management
Using the Menu Interface To View Stack Status and
Configure Stacking
Using the Menu Interface To View and Configure a
Commander Switch
1. Configure an IP address and subnet mask on the Commander switch.
(Refer to the Management and Configuration Guide for your switch.)
2. Display the Stacking Menu by selecting Stacking in the Main Menu.
Figure 13-5. The Default Stacking Menu
3. Display the Stack Configuration menu by pressing
[3] to select Stack
Configuration.
Figure 13-6. The Default Stack Configuration Screen
13-12
To Next Page
Loading...
