IP Routing Features
Configuring DHCP Relay
Viewing the Current DHCP Relay Configuration
Determining the DHCP Relay Setting. Use show config (or show running
for the running-config file) to list the current DHCP Relay setting. Note that
because DHCP Relay is enabled in the default configuration, it does not appear
in these listings unless it is disabled.
Non-Default DHCP-Relay Setting
Figure 11-26.Example of Startup-Config Listing with DHCP-Relay Disabled
Listing the Currently Configured DHCP Helper Addresses.
Syntax: show ip helper-address < vlan-id >
This command shows the currently configured IP Helper addresses,
regardless of whether DHCP-Relay is enabled. For example:
Figure 11-27.Example of Listing for IP Helper Addresses
11-75
To Next Page
Loading...
