HP ProCurve 5400zl User Manual

interface
OVERVIEW
Category:
configPrimary context:
show interfaces (page 560)Related Commands
Usage: [no] interface < [ethernet] PORT-LIST [...] | loopback <num> >
Description: Enter the Interface Conguration Level, or execute one
command for that level. Without optional parameters
specied, the 'interface' command changes the context to
the Interface Conguration Context Level for execution of
conguration changes to the port or ports in the PORT-LIST
or with loopback keywork it will change context to loopback
mode. Use 'interface ?' to get a list of all valid commands.
COMMAND STRUCTURE
■ [no] interface loopback < 0 to 7 > -- Enter the loopback Configuration Level (p. 248)
■ ip -- Configure various IP parameters for the Loopback (p. 240)
■ address -- Set IP parameters for communication within an IP network (p. 216)
■ ip-addr -- Interface IP address. (IP-ADDR) (p. 241)
■ ospf -- configure Open Shortest Path First (OSPF) protocol parameters on the interface (p.
256)
■ all -- Process the request for all IP addresses. (p. 219)
■ area -- Specify an OSPF area. (p. 221)
■ area-id -- Single integer or IP address style dotted decimal. (OSPF-AREA-ID) (p.
222)
■ backbone -- The backbone area (the same as 0.0.0.0). (p. 226)
■ cost < 1 to 65535 > -- Set metric of this interface. (p. 229)
■ ip-addr -- Specify the IP address the request is for. (IP-ADDR) (p. 241)
■ area -- Specify an OSPF area. (p. 221)
■ area-id -- Single integer or IP address style dotted decimal. (OSPF-AREA-ID) (p.
222)
■ backbone -- The backbone area (the same as 0.0.0.0). (p. 226)
■ cost < 1 to 65535 > -- Set metric of this interface. (p. 229)
■ interface port-list -- Enter the Interface Configuration Level, or execute one command for that
level ([ethernet] PORT-LIST) (p. 262)
■ arp-protect -- Configure the port as trusted or untrusted (p. 223)
■ trust -- (p. 279)
■ bandwidth-min -- Enable/disable and configure guaranteed minimum bandwidth settings for
outgoing traffic on the port(s) (p. 226)
■ output -- Enable/disable and configure guaranteed minimum bandwidth for outgoing traffic.
(p. 258)
■ queue1 < 0 to 100 > -- Specify min. bandwidth percentage for queue one outgoing traffic.
(p. 270)
■ queue2 < 0 to 100 > -- Specify min. bandwidth percentage for queue two outgoing
traffic. (p. 270)
■ queue3 < 0 to 100 > -- Specify min. bandwidth percentage for queue three outgoing
traffic. (p. 270)
204© 2009 Hewlett-Packard Development Company, L.P.

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English