Usage: [no] vrrp vrid <VRID> track interface <LPORT-LIST>
Description: Enable/disable tracking of logical ports for VR.
Next Available Option:
â– lport-list -- Enable/disable tracking of specified logical ports for VR ([ethernet] PORT-LIST) (p.
249)
interval
â– interface vlan VLAN-ID ip igmp querier interval < 5 to 300 >
Sets the interval in seconds between IGMP queries
(default: 125)
Range: < 5 to 300 >
â– interface vlan VLAN-ID ip-recv-mac-address MAC-ADDR interval
Specify the L3-Mac-Address timeout interval.
Next Available Option:
â– timer-interval < 1 to 255 > -- Timeout interval in seconds <1-255>. (p. 278)
ip
â– [no] interface [ETHERNET] PORT-LIST ip
Usage:
[no]
ip
access-group
<ACL-ID>
in
Description: Apply the speciîš¿ed access control list to inbound
packets on this INTERFACE list. The access
control list ACL-ID must be deîš¿ned before it can be applied.
Connection rate îš¿lter ACLs cannot be applied on this
INTERFACE list.
Next Available Options:
â– access-group -- Apply the specified access control list to inbound packets on this INTERFACE
list (ASCII-STR) (p. 214)
â– source-lockdown -- Enable/disable IP source lockdown in global configuration mode(p. 276)
â– [no] interface loopback < 0 to 7 > ip
Usage: [no] ip ...
Description: Conîš¿gure various IP parameters for the Loopback. The 'ip'
command must be followed by a feature-speciîš¿c keyword.
Use 'ip ?' to get a list of all possible options.
This is a Loopback context command. It can be called directly
from the Loopback context or follow the 'interface loopback
<num>' command.
Next Available Options:
â– address -- Set IP parameters for communication within an IP network(p. 216)
â– ospf -- configure Open Shortest Path First (OSPF) protocol parameters on the interface(p. 256)
240© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General