HP ProCurve 5400zl

telnet
OVERVIEW
Switch ManagementCategory:
managerPrimary context:
Related Commands
Usage: telnet <IPV4-ADDR|IPV6-ADDR|HOSTNAME|SWITCH-NUM>
Description: Initiate an outbound telnet session to another network device.
The destination can be specied using one of the following
parameter types:
o IPV4-ADDR - IPv4 address of device to telnet to.
o IPV6-ADDR - IPv6 address of device to telnet to.
o HOSTNAME - Hostname of device to telnet to.
o SWITCH-NUM - The stack member number to telnet to. (1..16)
This parameter can only be used if stacking is enabled,
and this switch is acting as a commander.
COMMAND STRUCTURE
■ telnet host-name -- Hostname of the device to connect to. (ASCII-STR) (p. 681)
■ telnet ipv4-addr -- IPv4 address of the device to telnet to. (IP-ADDR) (p. 681)
■ telnet ipv6-addr -- IPv6 address of the device to connect to. (IPV6-ADDR) (p. 681)
■ telnet SWITCH-NUM -- The stack member number to which to telnet. (NUMBER) (p. 682)
EXAMPLES
Example: telnet IP-ADDR
Establish a Telnet session with the device at IP address 10.0.0.2:
ProCurve(cong)# telnet 10.0.0.2
COMMAND DETAILS
ipv6-addr (p. 681)host-name (p. 681)
SWITCH-NUM (p. 682)ipv4-addr (p. 681)
host-name
■ telnet HOST-NAME
Hostname of the device to connect to.
ipv4-addr
■ telnet IP-ADDR
IPv4 address of the device to telnet to.
ipv6-addr
■ telnet IPV6-ADDR
681© 2009 Hewlett-Packard Development Company, L.P.