HP ProCurve 5400zl User Manual

poison-reverse
■ [no] interface vlan VLAN-ID ip rip poison-reverse
Enable/disable poison reverse on this interface.
■ [no] interface vlan VLAN-ID ip rip IP-ADDR poison-reverse
Enable/disable poison reverse on this interface.
■ [no] interface vlan VLAN-ID ip rip all poison-reverse
Enable/disable poison reverse on this interface.
port-list
■ interface [ETHERNET] PORT-LIST
Usage: [no] interface [ethernet] PORT-LIST [...]
Description: Enter the Interface Conguration Level, or execute one
command for that level. Without optional parameters
specied, the 'interface' command changes the context to
the Interface Conguration Context Level for execution of
conguration changes to the port or ports in the PORT-LIST.
The 'interface [ethernet] PORT-LIST' can be followed by any
command from the Interface Conguration Context Level in the
same command line. In this case the context level is not
changed, but the command is also executed for the port or ports
in the PORT-LIST. Use 'interface [ethernet] PORT-LIST ?'
to get a list of all valid commands.
Next Available Options:
■ ip -- Apply the specified access control list to inbound packets on this INTERFACE list(p. 240)
■ broadcast-limit < 0 to 99 > -- Set a broadcast traffic percentage limit(p. 228)
■ dhcp-snooping -- Configure the port as trusted or untrusted(p. 230)
■ disable -- Disable port(s)(p. 231)
■ enable -- Enable port(s)(p. 232)
■ flow-control -- Enable/disable flow control on the port(s)(p. 233)
■ gvrp -- Set the GVRP timers on the port (hundredths of a second)(p. 235)
■ lacp -- Define whether LACP is enabled on the port, and whether it is in active or passive mode
when enabled(p. 247)
■ mdix-mode < mdi | mdix | autoMDIX > -- Set port MDI/MDIX mode (default: auto).(p. 250)
■ monitor -- Define either the port is to be monitored or not(p. 252)
■ name -- Set/unset a name for the port(s)(p. 254)
■ power-over-ethernet -- Enable/Disable per-port power distribution(p. 263)
■ poe-allocate-by -- Control manual power over ethernet allocation(p. 261)
■ poe-value -- Maximum PoE allocation specified with a value in watts(p. 261)
■ poe-lldp-detect -- Enabling this feature causes the port to allocate power based on the
link-partner's capabilities via LLDP(p. 261)
■ qos -- Set port-based priority(p. 268)
■ speed-duplex < 10-half | 100-half | 10-full | ... > -- Define mode of operation for the port(s)(p.
276)
■ type < Trunk | | | ... > -- (p. 280)
■ unknown-vlans < Learn | Block | Disable > -- Configure GVRP on the port(s)(p. 281)
262© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English