HP ProCurve 5400zl

■ 8
■ 9
■ 10
■ 11
■ 12
■ 13
■ 14
■ 15
■ 16
■ 17
poe-allocate-by
■ interface [ETHERNET] PORT-LIST poe-allocate-by
Usage: poe-allocate-by [usage|class|value]
Description: Control manual power over ethernet allocation.
By default, power-over-ethernet allocation is automatic by
usage of the powered device. This can be overriden by manually
specifying how much power this port should be allocated by
either its class or a user-dened value.
Next Available Option:
■ allocate_by < usage | class | value > -- Control manual power over ethernet allocation(p. 221)
poe-lldp-detect
■ interface [ETHERNET] PORT-LIST poe-lldp-detect
Usage: poe-lldp-detect [disabled|enabled]
Description: Enabling this feature causes the port to allocate power
based on the link-partner's capabilities via LLDP.
By default, poe information detected though LLDP
are ignored as not all PoE devices properly support LLDP.
Next Available Option:
■ poe_lldp_detect < disabled | enabled > -- Enabling this feature causes the port to allocate power
based on the link-partner's capabilities via LLDP(p. 260)
poe-value
■ interface [ETHERNET] PORT-LIST poe-value
Usage: poe-value [1-17]
Description: Maximum PoE allocation specied with a value in watts.
By default, power-over-ethernet allocation is automatic by
usage of the powered device with a maximum set at 17W
This can be changed so the POE allocation is xed at
whatever poe-value is set to and by setting the port
allocation to be by value using: poe-allocate-by value.
Next Available Option:
■ poe_value < 1 | 2 | 3 | ... > -- Maximum PoE allocation specified with a value in watts(p. 260)
261© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide