HP ProCurve 5400zl

PIM-SM on the interface. Use 'ip pim-sparse ?' to get the list
of all conguration options. This command can be used in the
VLAN context or in the global context with the 'vlan <VLAN-ID>'
prex.
Next Available Options:
■ ip-addr -- Set the source IP address for the PIM-SM packets sent out on this interface(p. 241)
■ lan-prune-delay -- Turn on/off the LAN Prune Delay Option on this interface(p. 247)
■ hello-interval < 5 to 300 > -- Set the frequency at which PIM Hello messages are transmitted
on this interface(p. 236)
■ hello-delay < 0 to 5 > -- Set the maximum time before a triggered PIM Hello message is
transmitted on this interface(p. 236)
■ override-interval < 500 to 6000 > -- Set the value inserted into the Override Interval field of a
LAN Prune Delay option on this interface(p. 258)
■ propagation-delay < 250 to 2000 > -- Set the value inserted into the LAN Prune Delay field of
a LAN Prune Delay option on this interface(p. 266)
■ dr-priority -- Set the priority value to use on the interface in the Designated Router election
process(p. 231)
■ nbr-timeout < 60 to 8000 > -- Set the neighbour loss time interval for this interface(p. 255)
poe_lldp_detect
■ interface [ETHERNET] PORT-LIST poe-lldp-detect < disabled | enabled >
Usage: poe-lldp-detect [disabled|enabled]
Description: Enabling this feature causes the port to allocate power
based on the link-partner's capabilities via LLDP.
By default, poe information detected though LLDP
are ignored as not all PoE devices properly support LLDP.
Supported Values:
■ disabled
■ enabled
poe_value
■ interface [ETHERNET] PORT-LIST poe-value < 1 | 2 | 3 | ... >
Usage: poe-value [1-17]
Description: Maximum PoE allocation specied with a value in watts.
By default, power-over-ethernet allocation is automatic by
usage of the powered device with a maximum set at 17W
This can be changed so the POE allocation is xed at
whatever poe-value is set to and by setting the port
allocation to be by value using: poe-allocate-by value.
Supported Values:
■ 1
■ 2
■ 3
■ 4
■ 5
■ 6
■ 7
260© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide