HP ProCurve 5400zl User Manual

Range: < 0 to 100 >
■ interface [ETHERNET] PORT-LIST rate-limit all in percent < 0 to 100 >
Specify limit as percent of inbound or outbound trafc.
Range: < 0 to 100 >
■ interface [ETHERNET] PORT-LIST rate-limit all out percent < 0 to 100 >
Specify limit as percent of inbound or outbound trafc.
Range: < 0 to 100 >
■ interface [ETHERNET] PORT-LIST rate-limit bcast in percent < 0 to 100 >
Range: < 0 to 100 >
■ interface [ETHERNET] PORT-LIST rate-limit mcast in percent < 0 to 100 >
Range: < 0 to 100 >
pim-dense
■ [no] interface vlan VLAN-ID ip pim-dense
Usage: [no] ip pim-dense [...]
Description: Enable/disable/congure PIM-DM protocol on the VLAN interface.
Use direct and 'no' versions of the command to enable/disable
PIM-DM on the interface. Use 'ip pim-dense ?' to get the list
of all conguration options. This command can be used in the
VLAN context or in the global context with the 'vlan <VLAN-ID>'
prex.
Next Available Options:
■ ip-addr -- Set the source IP address for the PIM-DM packets sent out on this interface(p. 241)
■ lan-prune-delay -- Turn on/off the LAN Prune Delay Option on this interface(p. 247)
■ hello-interval < 5 to 300 > -- Set the frequency at which PIM Hello messages are transmitted
on this interface(p. 236)
■ hello-delay < 0 to 5 > -- Set the maximum time before a triggered PIM Hello message is
transmitted on this interface(p. 236)
■ graft-retry-interval < 1 to 10 > -- Set the interval a PIM router waits for a Graft Ack before
resending a Graft on this interface(p. 235)
■ max-graft-retries < 1 to 10 > -- Set the maximum number of times this router will resend a
Graft on this interface(p. 249)
■ override-interval < 500 to 6000 > -- Set the value inserted into the Override Interval field of a
LAN Prune Delay option on this interface(p. 258)
■ propagation-delay < 250 to 2000 > -- Set the value inserted into the LAN Prune Delay field of
a LAN Prune Delay option on this interface(p. 266)
■ ttl-threshold < 0 to 255 > -- Set the Time To Live in a PIM-DM State Refresh message at which
it is not forwarded on this interface(p. 279)
pim-sparse
■ [no] interface vlan VLAN-ID ip pim-sparse
Usage: [no] ip pim-sparse [...]
Description: Enable/disable/congure PIM-SM protocol on the VLAN interface.
Use direct and 'no' versions of the command to enable/disable
259© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English