An IPv6 EUI-64 address that can be automatically conîš¿gured on any interface
â– [no] interface svlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN eui-64
An IPv6 EUI-64 address that can be automatically conîš¿gured on any interface
failback
â– interface vlan VLAN-ID vrrp vrid < 1 to 255 > failback
Usage: vrrp vrid <VRID> failback
Description: Trigger VR to failback to its conîš¿gured priority value.
failover
â– interface vlan VLAN-ID vrrp vrid < 1 to 255 > failover
Usage: vrrp vrid <VRID> failover [with-monitoring]
Description: Trigger VR to failover to a peer.
If keyword 'with-monitoring' is speciîš¿ed, VR continues
to monitor master VR.
Next Available Option:
â– with-monitoring -- Trigger VR to failover and continue montior of master VR(p. 289)
fastleave
â– [no] interface vlan VLAN-ID ip igmp fastleave [ETHERNET] PORT-LIST
Usage: [no] ip igmp fastleave [ethernet] PORT-LIST
Description: Enables or disables IGMP Fast Leaves. When enabled, as soon as
an IGMP Group Leave has been received on a non-cascaded port,
the switch stops forwarding multicast trafîš¿c for that group
to that port.
Does not apply to cascaded ports (see ip igmp forcedfastleave).
When disabled, or when the port is cascaded, the regular IGMP
leave time is used (up to 10 seconds when the switch is not
the IGMP Querier).
The default behavior is for IGMP FastLeaves to be enabled.
This feature is conîš¿gured for ports on a per-VLAN basis.
â– [no] interface vlan VLAN-ID ipv6 mld fastleave [ETHERNET] PORT-LIST
Usage: [no] ipv6 mld fastleave < port-list >
Description: Enables MLD fast-leaves on the speciîš¿ed ports in the selected VLAN.
The no form of the command disables MLD fast-leave on the speciîš¿ed
ports in the selected VLAN.
flow-control
â– [no] interface [ETHERNET] PORT-LIST flow-control
Usage: [no] ow-control
Description: Enable/disable ow control on the port(s). By default,
233© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General